Readers
Secrets
Float
a Fly for a Bass
By Don Wirth
The
float 'n' fly system can heat up your fishing in cold
weather.
Every
so often a bass-fishing technique comes along that’s
disarming in its simplicity, yet absolutely deadly when
properly executed. Such is the case with the float ’n’
fly, the most innovative method for catching bass in
clear, cold water to surface in years.
While it’s especially potent on smallmouths, it
will catch largemouth and spotted bass as well. And
because it works better than any system in hyper-chilled
water, it will extend your bass-fishing season by weeks,
if not months. Don’t hang up your rods and put
your bass boat in winter storage until you read what
follows.
Solution
for Suspenders
The float ’n’ fly system was developed by
eastern Tennessee angler Charlie Nuckols as a method
of teasing sluggish smallmouth bass to bite in clear,
frigid water. Nuckols, owner of Bullet Lures, knew that
once the water temperature dipped below 45 degrees in
winter, the bass in his local reservoirs became so lethargic
they were virtually impossible to catch. Nuckols could
see fish on his graph. He just couldn’t catch
them by conventional means. The bass suspended in the
water off rock bluffs or deep points. He tried to catch
them on a jigging spoon, but even this old winter standby
would falter once the water temperature dropped into
the low 40s. Sometimes the bass wouldn’t budge
regardless of what the angler did to elicit a response.
Nuckols
suspected that the answer to the slow-bite riddle would
be a small lure fished for extended periods at the depth
at which the smallmouths suspended. Instead of trying
to trigger reaction strikes, Nuckols decided a soft
sell was better. He started experimenting with tiny
crappie jigs dangled under a bobber and soon began catching
bass. The more he refined the concept, the more fish
he caught, until he eventually arrived at what many
bronzeback aficionados feel is the ultimate system for
big smallmouths in cold, clear water: the float ’n’
fly.
Charlie
Nuckols drowned in a boating accident in 1996, just
as his revolutionary bass system was gaining a following
among smallmouth anglers. Today, Charlie’s brother
Eddie runs Bullet Lures, which remainsthe main source
for the specialized lures and equipment used with the
float ’n’ fly system
How
it Works
One reason for the float ’n’ fly’s
popularity, beyond its effectiveness, is its simplicity.
The float ’n’ fly system consists of three
basic components:
1.
A tiny leadhead jig, or “fly,” tied with
craft hair (a crinkly man-made material frequently used
in the toy industry). When suspended beneath a bobber
in clear water, a craft- hair jig will puff out, or
“breathe.”
Consequently,
the small jig (usually 1/16 ounce and 2 inches long)
resembles one of the diminutive lake minnows that suspending
bass feed on in winter.
2.
A small (¾- to 1-inch) plastic bobber. Float
’n’ fly fanatics insist on a stationary
float as opposed to a slip bobber. The float is clipped
onto the line from 8 to 13 feet above the fly. The float
bobs on the surface and keeps the jig suspended at the
desired depth. It’s simple, but effective.
3.
A long, flexible spinning rod.
Anglers
proficient with the system use two-piece rods 8 to 11
feet long. The rod should have a super-soft action,
almost like a flyrod, to cast the lightweight jig and
float long distances and to provide the shock absorption
needed to prevent huge bass from popping light line.
This rod is paired with a spinning reel loaded with
small-diameter 4- or 6-pound-test monofilament line.
The
Big Chill
The float ’n’ fly method is most effective
in clear water with a temperature between 38 and 48
degrees. It absolutely shines when the water is in the
low 40-degree range—a period when many reservoir
smallmouth anglers have traditionally hung up their
rods. “I got two big surprises when I first began
using the float ’n’ fly in midwinter,”
Tennessee bass guide Jim Duckworth says. “I was
amazed at the sheer number of fish I caught. And I was
stunned by the fact that even larger bass will go after
those small jigs. Four-pound smallmouths are common
with this method.”
When
the water is extremely cold, suspending bass are in
a totally neutral mood, Duckworth explains. “Their
metabolism is cranked down so low and their digestion
process so sluggish, they don’t feed very often.
But they will strike a tiny lure dangled right in their
faces.”
Where
to Fish
The float ’n’ fly works wherever smallmouths
suspend in winter. High- percentage spots include:
Bluff banks
Rocky points, especially those with a quick drop into
deep water
Sloping rock or clay banks (aka “45-degree”
banks)
Flats or bars adjacent to any of the above structures
Open water in “hollows” (deep, narrow, V-shaped
tributary arms) “The float ’n’ fly
method is ridiculously simple,” says Duckworth.
“First, idle your boat around in a likely area
and locate suspending fish with your graph or flasher.
The most ‘catchable’ bass will be hanging
eight to fifteen feet below the surface.”
Once the depth of the fish has been determined, peel
sufficient line off the reel and position the bobber
so the fly will be presented at the bass’s depth,
or slightly above them.
Next,
cast the rig to your target. “I like to either
work the rig back to the boat with short twitches of
the rod tip, or, if the water is choppy, just let it
set there and let the wave action activate the bobber
and fly,” Duckworth says. “Slower is better
because bass are likely to be sluggish and won’t
chase a fly.” As with most fishing techniques,
the float ’n’ fly method works better at
some times than at others. “On windy, overcast
days, smallies tend to suspend shallower and are highly
susceptible to this technique,” Duckworth notes.
“The bite often gets tougher when the sun comes
out and fish go deeper; that’s when it’s
better to target shady bluffs or windy banks. Dead-calm,
sunny days also are bad; try setting the float as high
above the fly as you can cast it, or look for dingy
water where the fish are likely to be shallower.”
A
major part of the fun of using the float ’n’
fly system is that it might take five minutes to land
a lunker on that soft-action rod and wispy line. But
then, what else do you have to do on a cold winter day?
|