Readers Secrets

Unlocking a River's Secrets
By Chad Mason

Fish have favorite spots in and out of the current; learn how to read a river and you'll load your boat.

Rivers don’t get fished as much as they should. Many anglers feel intimidated by water that won’t stand still and therefore congregate on lakes, ponds and reservoirs.

If you develop some basic “reading” skills, however, you’ll find rivers far less perplexing. For several years I’ve fished rivers and streams almost exclusively and have enjoyed uncrowded angling for walleyes, catfish, bass, pike and crappies. Here’s how to expand your angling repertoire to include moving waters.

The Run of a River
Unless they’ve been straightened by man-made excavation, all rivers share a basic shape. Although the width of their meanders may differ, rivers wander back and forth in a succession of S-shaped curves.The river’s main current sweeps along the outside bends and disperses across the river’s midsection in the straightaway between bends.

The river’s deepest water will be found on the outside bends, where the full force of the current scours deep holes. This is where fish in that area of the river will stay most of the time, whether feeding or not. Often the outside bend will have a steep bank. On many rivers, engineers install rock riprap to curb erosion on the outside bends. Riprap frequently provides good fishing for smallmouth bass, white bass and walleyes. Catfish will also use riprap areas during their spawning season. Where riprap is not installed, erosion may undercut mature trees and topple them into the water, creating ideal habitat for crappies, catfish or pike.

The river’s shallowest water will be located on the inside bends and in the straightaways between bends. Because the current is relatively slow on inside bends, sand and fine gravel will deposit here to form a soft, shallow bar. Riffles will often be found in the straightaways, where the river gurgles over shallow rocks. On smaller rivers, bars and riffles create hazards for boaters and access for wading anglers. The best place for a wading angler to cross a small river is diagonally through the straightaway, from inside bend to inside bend. However, make a few casts before crossing; fish often prowl riffles and bars for minnows and crayfish, especially in periods of low light. The downstream end of the riffle, where it plunges into the next deep hole, is also a good fish location.

With the basic riparian shape firmly in mind, you can predict water depth and bottom content in a river, even if poor water clarity makes the bottom difficult to see. Knowing a river’s basic shape will boost your confidence in wading, boating, and fishing it. But you must still master another skill: deciphering the river’s currents and how fish relate to them.

In any given stretch of river, current speed is not constant from bank to bank or top to bottom. Current speed varies with lateral position and depth. Regarding lateral position, the current speed is slowest at the banks and increases as it gets closer to the river’s main line of current. With regard to depth, the current speed is slowest at the bottom and increases as it rises toward the surface. Some fish will hold near the bank, just off the main current; their food comes alongside them on the main current. Other fish will hold at midriver, near the bottom; their food drifts over them on the main current. To catch river fish consistently, present a bait or lure in the feeding lane between the main current and the slack water where fish are holding.

Bank irregularities or obstructions in the river create further variations in current speed and thus more places where fish might hold. For example, midstream boulders, shoreline jetties, bridge pillars and fallen trees along the bank create pockets of slack water—eddies—on their downstream side, where fish might hold. Usually the largest and most active fish will occupy the best feeding locations at the upstream end of the eddy, closest to the obstruction. In all cases, fish will face into the current. This means that some fish will actually face downriver, since the eddy’s current swirls in a circular motion.

A river shares its secrets at the surface. Pay attention to lines, curves and swirls on the water. They show where feeding lanes exist. Note the general character of the surface: a smooth, glassy surface indicates a flat, relatively featureless and probably soft bottom, whereas a dimpled or “boiling” surface indicates a rocky bottom. A surface dimple or boil will be located downstream from the boulder that causes it; how far depends on the current’s force. To reach a fish holding in the boulder’s pocket, cast upstream of the surface boils and work the bait down the side or top of the structure.